Using Cli Shortcuts - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
Mode Access by...
Line specifying a line (console or Telnet)
while at the Global Configuration mode
prompt.
For example:
>enable
#config term
(config)#line console 0
Router entering router rip or router ospf
while at the Global Configuration mode
prompt.
For example:
>enable
#config term
(config)#router rip
Interface specifying an interface (T1, Ethernet,
Frame Relay, ppp, etc.) while in the
Global Configuration mode.
For example:
>enable
#config term
(config)#int eth 0/1

Using CLI Shortcuts

The ADTRAN CLI provides several shortcuts which help you configure your AOS product more easily.
See the following table for descriptions.
Shortcut Description
Up arrow key To re-display a previously entered command, use the up arrow key. Continuing to press the
up arrow key cycles through all commands entered starting with the most recent
command.
<Tab> key Pressing the <Tab> key after entering a partial (but unique) command will complete the
command, display it on the command prompt line, and wait for further input.
61200990L1-35E
Sample Prompt
(config-con0)#
(config-rip)#
(config-eth 0/1)#
(The above prompt is for the
Ethernet LAN interface located
on the rear panel of the unit.)
Copyright © 2005 ADTRAN
Using CLI Shortcuts
With this mode you
can...
• configure the
console terminal
settings (datarate,
login password, etc.)
• create Telnet logins
and specify their
parameters (login
password, etc.)
• configure RIP or
OSPF parameters
• suppress route
updates
• redistribute
information from
outside routing
sources (protocols)
• configure
parameters for the
available LAN and
WAN interfaces
10