Default Settings; Device Status - Avaya G450 Cli Reference Manual

Roadmap

Default settings

Table 20: Default gateway CLI commands
Command
zeroize

Device status

Table 21: Device status commands
Command
clear utilization cpu
set utilization cpu
show download
show faults
show mg list_config
show mgc
show mm
show module
show recovery
show restart-log
show system
56 Avaya G450 CLI Reference
Description
Clear all secret parameters and initialize the NVRAM to
its factory defaults
Description
Disable CPU utilization measurements
Enable CPU utilization measurements
Display the status of the current file copy process to the
device
Display information about currently active faults
Display the current hardware and firmware
configurations for the installed media gateway
equipment
Display information about the Media Gateway
Controller with which the G450 is registered
Display information about media modules that are
installed on the G450
Display brief information about the media modules
installed in the G450
Display the G450 monitoring and recovery setup
Display information about the last time that the G450
was reset
Display information about the G450
1 of 2