Frame Relay Encapsulation - Avaya G450 Cli Reference Manual

Frame relay encapsulation

Table 37: Frame relay CLI commands
Root level command
clear frame-relay
counters
interface serial
map-class frame-relay
First level command
encapsulation
frame-relay
class-dlci
frame-relay
interface-dlci
frame-relay
lmi-n391dte
frame-relay
lmi-n392dte
frame-relay
lmi-n393dte
frame-relay
lmi-type
frame-relay
priority-dlci-group
frame-relay
traffic-shaping
ip address
Description
Clear the frame relay counters
Enter Serial interface or sub-interface
configuration mode
Set the encapsulation mode for a
Serial interface
Associate a Virtual Channel with a
named QoS or Traffic shaping
template (map-class)
Associate a frame relay Virtual
Channel with the current interface
Set the number of status enquiry
intervals that pass before issuing a full
status enquiry message
Set the maximum number of
unanswered status enquiries the
equipment accepts before declaring
the interface down
Set the number of status polling
intervals over which the error threshold
is counted (the monitored event count)
Manually define the type of the Local
Management Interface (LMI) to use
Assign Virtual Channels to priority
classifications, for supporting traffic
separation
Turn on or turn off traffic shaping and
frame relay fragmentation
Configure an IP address and mask for
the interface
Create a QoS template which can later
be assigned to DLCIs
Issue 1 January 2008
1 of 2
71