Renault Laguna III Manual page 692

TOP AND FRONT OF ENGINE
Oil decanter: Removal - Refitting
K4M
Tightening torquesm
new oil separator bolts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove:
- the engine cover,
- the three coils on the flywheel end (see 17A, Igni-
tion, Coils: Removal - Refitting, page 17A-1) ,
- the throttle valve (see 12A, Fuel mixture, Throttle
valve: Removal - Refitting, page 12A-49) ,
- the intake distributor (see 12A, Fuel mixture, Inlet
distributor: Removal - Refitting, page 12A-75) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove:
- the bolts (1) from the oil separator,
- the oil decanter.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the oil separator filter.
15 N.m
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.
WARNING
When cleaning par ts, it is essential that the parts
do not impact on each other, otherwise their mat-
ing faces may be damaged and therefore their
adjustments may be altered, which could dam-
age the engine.
a Clean using SUPER CLEANING AGENT FOR
JOINT FACES (see Vehicle: Parts and consuma-
bles for the repair) (04B, Consumables - Products):
- the oil separator joint face if it is to be re-used,
- the rocker cover joint face.
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consum-
ables - Products) to degrease:
- the oil separator joint face if it is to be re-used,
- the rocker cover joint face.
WARNING
The joint faces must be clean, dry and free from
grease (avoid finger marks).
WARNING
Applying excess sealant could cause it to be
squeezed out when parts are tightened. A mix-
ture of sealant and fluid could damage certain
components (engine, radiator, etc.).
128402
11A-314
11A