Vrrp-Group - Dell Z9500 Command Reference Manual

Related vrrp delay minimum
Command reboot.

vrrp-group

Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Z9500
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage The VRRP group only becomes active and sends VRRP packets when a virtual IP
Information address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
Related virtual-address
Command
Virtual Router Redundancy Protocol (VRRP)
— sets the delay time for VRRP initialization after a line card
Enter a number as the group ID. The range is from 1 to 255.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— assigns up to 12 virtual IP addresses per VRRP group.
1899