Show Ip Pim Interface - Dell Force10 Z9000 Reference Manual

show ip pim interface

View information on the interfaces with IP PIM enabled.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip pim interface
Command Modes
Command History
Version 8.3.11.1
Version 8.3.12.0
Version 8.1.1.0
Version 7.8.1.0
Usage The following describes the show ip pim interface command shown in the Example
Information below.
Field
Address
Interface
Ver/Mode
Nbr Count
Query Intvl
DR Prio
DR
Example
E600-7-RPM0#show ip pim interface
Address
172.21.200.254 Gi 7/9
172.60.1.2
192.3.1.1
192.4.1.1
1140
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Description
Lists the IP addresses of the interfaces participating in PIM.
List the interface type, with either slot/port information or ID (VLAN
or Port Channel), of the interfaces participating in PIM.
Displays the PIM version number and mode for each interface
participating in PIM:
•
•
Displays the number of PIM neighbors discovered over this
interface.
Displays the query interval for Router Query messages on that
interface (configured with ip pim query-interval
command).
Displays the Designated Router priority value configured on the
interface (use the ip pim dr-priority command).
Displays the IP address of the Designated Router for that interface.
Interface Ver/ Nbr
Gi 7/11
Gi 7/16
Gi 13/5
v2 = PIM version 2
S = PIM Sparse mode
Query DR
Mode Count Intvl Prio
v2/S 0 30 1
v2/S 0 30 1
v2/S 1 30 1
v2/S 0 30 1
DR
172.21.200.254
172.60.1.2
192.3.1.1
192.4.1.1