Avaya S8700 Maintenance Manual page 1916

Maintenance-Object Repair Procedures
DS1 OPS Switchhook Inquiry Test (#312)
This test initiates the Switchhook Audit test. The test queries the switchhook state
of the Off-Premises-Station in switch software. If the state in switch software
disagrees with the state on the DS1 Interface circuit pack, then the state in the
switch software is updated to match the state on the DS1 Interface circuit pack.
Table 8-488. Test #312 DS1 OPS Switchhook Inquiry Test
Error Test
Code Result Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port has been seized by a user for a valid call. Use the status station
command to determine when the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT Test failed due to incompatible configuration administered in station
administration.
1. Using the display station command, verify that the station is not the 24th
1006 ABORT The test was aborted because the station is out of service. This condition may
be accompanied by an error type 18 entry in the error log. You may want to
determine why the station was taken out of service. (When stations are taken
out of service by maintenance software, the problems that led up to that must
be cleared.)
1. Use the status station command to check the state of the port. If the port
2. Retry the command at 1-minute intervals up to 5 times.
1020 ABORT The DS1 Interface circuit pack is out-of-service.
1. Look for DS1-BD/UDS1-BD errors in Hardware Error Log. If present, see
2. Retry the command.
8-1194 Issue 1 May 2002
port of the DS1 Interface circuit pack while common channel signaling is
specified. Use the display ds1 command to check the signaling type of
the DS1 circuit pack.
is indeed out of service, enter the release station command to bring the
station back into service.
the appropriate error ''DS1-BD (DS1 Interface Circuit Pack)'' on page
8-586.
Continued on next page
555-233-143