Avaya S8700 Maintenance Manual page 1895

M/T-DIG (Maintenance/Test Digital Port)
Table 8-480. Test #565 Digital Port Sanity Test — Continued
Error Test
Code Result Description / Recommendation
50 FAIL The switch was unable to communicate with the port circuitry used for digital
trunk testing.
100 FAIL Data was not sent from port 2 to port 3 successfully in asynchronous mode.
101 FAIL Data was not sent from port 3 to port 2 successfully in asynchronous mode.
102 FAIL Data was not sent from port 2 to port 3 successfully in synchronous mode.
103 FAIL Data was not sent from port 3 to port 2 successfully in synchronous mode.
1. Reset the circuit pack via the busyout board UUCSS, reset board
2. Test the port again via the test port UUCSS02 l command.
3. If the test fails again, replace the circuit pack.
PASS The Maintenance/Test digital port digital trunk testing capability is operating
correctly.
555-233-143
UUCSS, release board UUCSS command sequence.
Continued on next page
Issue 1 May 2002 8-1173