Avaya S8700 Maintenance Manual page 1957

PKT-BUS (Packet Bus)
Table 8-505. Test #572 Maintenance/Test Circuit Pack Query Test
Error Test
Code Result Description / Recommendation
1006 ABORT The packet bus port of the Maintenance/Test circuit pack is out of service.
1. Determine whether the port is busied out. If so, release it with the release
2. If there are alarms active against the packet bus port (MT-PKT), see
1142 ABORT No Maintenance/Test circuit pack packet bus port is in service in this PN.
1. If this PN is required by configuration guidelines to have a
2. In an PN of a system without PNC duplication, the Maintenance/Test
2000 ABORT The test timed-out while waiting for an uplink CCMS response from the
Maintenance/Test packet bus port.
1. Re-enter the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, check for problems with the Maintenance/Test
2059 ABORT The Maintenance/Test packet bus port has reported a hardware failure.
1. See
2. Re-enter the test command.
555-233-143
port UUCSS04 command. Then retry the test command.
''M/T-PKT (Maintenance/Test Packet Bus Port)''
retry the test command.
Maintenance/Test circuit pack:
a. the Maintenance/Test circuit pack for this PN has failed, and should be
replaced,
b. the Maintenance/Test circuit pack has been busied out, and should be
released, or
c. there is no Maintenance/Test circuit pack in thisPN, and one must be
installed.
packet bus Port is not required and may not be present. If it is present, and
is busied out, or has failed, release or replace the circuit pack. If there is
no Maintenance/Test circuit pack, ignore the results of this test for this PN.
packet bus port (look for M/T-PKT in the Error and Alarm Logs).
''M/T-PKT (Maintenance/Test Packet Bus Port)''
problem.
to resolve them. Then
to correct the
Continued on next page
Issue 1 May 2002 8-1235