Avaya S8700 Maintenance Manual page 1888

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

Table 8-477. Test #9 NPE Cross Talk Test — Continued

Description / Recommendation

Response to the test request was not received within the allowable time period.

System resources required to run this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to abort, escalate the problem.

The NPE of the tested port was found to be transmitting in error. This will

cause noisy and unreliable connections.

1. If the remaining ports are currently idle (amber LED is off), try to reset the

2. If the test fails again, replace circuit pack.

The port is correctly using its allocated time slots. User-reported troubles on

this port should be investigated using other port tests and by examining station,

trunk, or external wiring.

Issue 1 May 2002

circuit pack. Then repeat the test.

Continued on next page

Troubleshooting