Avaya S8700 Maintenance Manual page 1860

Maintenance-Object Repair Procedures
Modem Pool NPE Crosstalk Test (#96)
This test is destructive.
The Modem Pool Crosstalk test verifies that the NPE is connected only to the
desired time slot and is not crosstalking on other time slots. This test operates
exactly like Test #6 for other types of port circuits but is performed twice in order to
test both NPEs in the Modem Pool Port.
Table 8-467. Test #96 Modem Pool NPE Crosstalk Test
Error Test
Code Result Description / Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required for this test are not available. The port may be in
use on a valid call. Determine whether the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1001 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions, or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present or some Tone Detectors
may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals up to 5 times.
1004 ABORT The port has been seized by a user for a valid call. Determine whether the port
is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1020 ABORT The test did not run due to a previously existing error on the specific port or
because of a more general circuit pack error.
1. Examine the Error Log for existing errors against this port or the circuit
2000 ABORT A response to the test was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
8-1138 Issue 1 May 2002
repeat the test at 1-minute intervals up to 5 times.
pack, and attempt to diagnose the previously existing errors.
Continued on next page
555-233-143