Enable Snmp Trap Updown - H3C S7500E Series Command Reference Manual

Field
Status
Priority
Oper-Key
Flag
Remote
Actor
Partner

enable snmp trap updown

Syntax
enable snmp trap updown
undo enable snmp trap updown
View
Layer 2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the enable snmp trap updown command to enable link state trapping for the current aggregate
interface.
Use the undo enable snmp trap updown command to disable link state trapping for the current
aggregate interface.
By default, link state trapping is enabled for an aggregate interface.
With the link state trapping function enabled, an aggregate interface generates linkUp trap messages
when its link goes up and linkDown trap messages when its link goes down.
Note that for an aggregate interface to generate linkUp/linkDown traps when its link state changes, you
must also enable link state trapping globally with the snmp-agent trap enable [ standard [ linkdown |
linkup ] * ] command.
For more information about the snmp-agent trap enable command, see SNMP Configuration
Commands in the Network Management and Monitoring Command Reference.
Examples
# Enable linkUp/linkDown trap generation on Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] snmp-agent trap enable
Port state: selected or unselected
Port LACP priority
Operational key
LACP protocol state flag
Information about the remote end
Local port type and number
Remote port index
9-14
Description