Tunnel Mpls Path-Option - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

tunnel mpls path-option

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
tunnel mpls [ traffic-eng ] path-option number
{ dynamic | explicit { name pathName | identifier idNumber } }
[ hop-by-hop | ospf | isis ] [ lockdown ]
no tunnel mpls [ traffic-eng ] path-option number
Command introduced before JunosE Release 7.1.0.
Specifies the path options for a tunnel. You can configure one or more path options—each
identified by a unique number—for a given tunnel. The path option number expresses
the preference for that option; lower numbers have a higher preference, with 1 having the
highest preference. The no version deletes the path options.
traffic-eng—Specifies optional keyword for compatibility with non–E Series
implementations
number—Identifier for a set of path options
dynamic—Specifies that the path is dynamically calculated
explicit—Specifies that an explicit path is used
pathName—Name of the explicit path; string of up to 20 characters
idNumber—Number identifying the explicit path; in the range 1–65535
hop-by-hop—Specifies that hop-by-hop routing is used for this path option
ospf—Specifies that OSPF routing is used for this path option
isis—Specifies that IS-IS routing is used for this path option
lockdown—Specifies that optimization is not done for this path option
Interface Configuration, Tunnel Profile Configuration
Chapter 8: T Commands
1363