Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
tunnel mpls autoroute metric
Syntax
Release Information
Description
Options
Mode
1356
tunnel mpls [ traffic-eng ] autoroute metric { absolute | relative } metricValue
no tunnel mpls [ traffic-eng ] autoroute metric
Command introduced before JunosE Release 7.1.0.
Specifies the tunnel metric. The value determines tunnel preference when there is more
than one tunnel or native IP path to a tunnel endpoint. A lower value is preferred to a
higher value. When you set up multiple tunnels, if the primary tunnel goes down, the
existing tunnel with the lowest metric is used immediately. If you specify an absolute
value from 1–2147483647, this value overrides the metric for the path provided by the
IGP. If you specify a relative value from –10 to +10, this value is subtracted from (–) or
added to (+) the metric for the path provided by the IGP. The no version restores the
default value, relative 0, meaning that the tunnel metric is the IGP value.
traffic-eng—Specifies optional keyword for compatibility with non–E Series
implementations
absolute—Specifies that the metric is an absolute value
relative—Specifies that the metric is a signed relative value
metricValue—Preference value for a path; absolute values are in the range
1–2147483647; relative values are in the range –10–+10
Interface Configuration, Tunnel Profile Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
