Vlan Policy - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

vlan policy

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
vlan policy { input | output } policyName
[ statistics { enabled [ baseline { enabled | disabled } ] [ preserve | merge ] |
disabled [ merge ] } | merge ]
no vlan policy { input | output } [ policyName ]
Command introduced before JunosE Release 7.1.0.
merge keyword added in JunosE Release 7.2.0.
Profile Configuration mode added in JunosE Release 7.2.0.
Assigns a VLAN policy list to an interface. If you enter the vlan policy command and the
policy list does not exist, the router creates a policy list with no rules, the default. When
no rules are found in a policy list, the router performs a routing table lookup and forwards
packets on the interface based on the routing table information. You must specify the
input or output keyword to assign the policy list to the ingress or egress of the interface.
In Profile Configuration mode, assigns the policy list to a profile, which then assigns the
policy to an interface.
In Interface Configuration mode, the no version removes the association between a policy
list and an interface. In Profile Configuration mode, the no version removes the policy
reference from the profile.
input—Applies policy to data arriving at this interface
output—Applies policy to data leaving this interface
policyName—Name of the policy; a maximum of 40 characters
statistics—Enables or disables collection of policy routing statistics
enabled—Enables collection of policy routing statistics
baseline enabled—Enables baselining of policy routing statistics
baseline disabled—Disables baselining of policy routing statistics
preserve—Preserves existing statistics for any classifier list that is the same for both
the new and old policy attachments when you attach a new policy to an interface
disabled—Disables collection of policy routing statistics
merge—Enables merging of multiple policies to form a single policy
Interface Configuration, Profile Configuration
Setting a Statistics Baseline for Policies
Chapter 9: U, V, W, and Y Commands
1419