Vlan Bulk-Config Modify - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

vlan bulk-config modify

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
To modify VLAN ranges containing single-tagged VLAN IDs:
vlan bulk-config bulkConfigName modify vlan-range vlanIdStart vlanIdEnd
To modify VLAN ranges containing double-tagged S-VLAN IDs or based on
agent-circuit-identifier:
vlan bulk-config bulkConfigName modify svlan-range s-vlanIdStart s-vlanIdEnd
{ vlanIdStart vlanIdEnd | any | agent-circuit-identifier }
Command introduced in JunosE Release 7.3.0.
Modifies the VLAN subrange values for the specified bulk configuration VLAN range. If
the new subrange encompasses previously configured subranges within that range, those
subranges are merged into the new one, freeing subrange resources. There is no no
version.
bulkConfigName—Name of the VLAN range; string of up to 80 characters
vlanIdStart—Starting VLAN ID of the VLAN subrange you are configuring
vlanIdEnd—Ending VLAN ID of the VLAN subrange you are configuring
s-vlanIdStart—Starting S-VLAN ID of the S-VLAN subrange you are configuring
s-vlanIdEnd—Ending S-VLAN ID of the S-VLAN subrange you are configuring
any—Specifies the VLAN ID as a wildcard
agent-circuit-identifier—Specifies a VLAN range that is based on agent-circuit-identifier
information
Interface Configuration
Chapter 9: U, V, W, and Y Commands
1413