Tunnel Mpls Diff-Serv Phb-Id - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

tunnel mpls diff-serv phb-id

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
tunnel mpls diff-serv phb-id { private privateId | standard standardId } [ exp-bits expBits
]
no tunnel mpls diff-serv phb-id { private privateId | standard standardId }
Command introduced before JunosE Release 7.1.0.
Specifies the PHB supported by a signaled tunnel.
For E-LSPs, this command also maps the PHB to the specified EXP bits bitValue. You
can repeat the command for up to eight PHB mappings.
For L-LSPs, the exp-bits keyword is not used. If you repeat the command, the most recent
command overwrites the previous command.
The no version removes the mapping association.
privateId—Number, in the range 0–4095, designating the private PHB identifier
standardId—Number, in the range 0–63, designating the standard identifier using the
DSCP bits
expBits—Number, in the range 0–7, designating the EXP bits
Interface Configuration, Tunnel Profile Configuration
Chapter 8: T Commands
1359