Table of Contents
Advertisement
tunnel mpls retries
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
tunnel mpls retries retryNum
no tunnel mpls retries
Command introduced before JunosE Release 7.1.0.
Specifies for a particular tunnel the number of attempts that will be made to set up an
LSP for RSVP-TE after a failure other than one due to no available route. The no version
restores the default value, 0, which means the attempts will be made until successful.
retryNum—Number of retry attempts in the range 0–65535
Interface Configuration, Tunnel Profile Configuration
Chapter 8: T Commands
1365
Advertisement
Table of Contents
