Vbr-Rt - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

vbr-rt

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
vbr-rt pcr scr mbs
no vbr-rt
Command introduced in JunosE Release 7.1.0.
ATM VC Class Configuration mode added in JunosE Release 7.3.0.
In ATM VC Configuration mode, configures the variable bit rate, real time (VBR-RT)
service category on an ATM PVC. You must specify the peak cell rate (PCR), sustained
cell rate (SCR), and maximum burst size (MBS). The vbr-rt command is valid only for
data PVCs; you cannot use this command for control (ILMI or signaling) PVCs. The no
version restores the default service category, unspecified bit rate (UBR) without a PCR.
In ATM VC Class Configuration mode, configures the VBR-RT service category as part of
a VC class definition that you assign to an ATM PVC. The no version restores the default
service category, UBR without a PCR, in the VC class.
pcr—Peak cell rate, in Kbps, in the range 0–149760 (for OC3 ATM modules) or
0–599040 (for OC12 ATM modules)
scr—Sustained cell rate, in Kbps, in the range 0–149760 (for OC3 ATM modules) or
0–599040 (for OC12 ATM modules)
mbs—Maximum burst size, in cells, in the range 0–16777215
ATM VC Configuration, ATM VC Class Configuration
Chapter 9: U, V, W, and Y Commands
1403