Tunnel Transform-Set - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

tunnel transform-set

Syntax
Release Information
Description
Options
Mode
1378
[ no ] tunnel transform-set transformSetName
Command introduced before JunosE Release 7.1.0.
Specifies a transform set that ISAKMP uses during SA negotiations on this tunnel.
Transform sets used for manually configured tunnels can have only one transform. The
no version removes the transform set from a tunnel.
transformSetName—Name of the transform set
Interface Configuration
Copyright © 2010, Juniper Networks, Inc.