Tunnel Mpls No-Route Retries - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

tunnel mpls no-route retries

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
tunnel mpls no-route retries retryNum
no tunnel mpls no-route retries
Command introduced before JunosE Release 7.1.0.
Specifies for a particular tunnel the number of attempts that will be made to set up an
LSP for RSVP-TE after a failure due to no available route. The no version restores the
default value, 0, which means the attempts will be made until successful.
retryNum—Number of retry attempts in the range 0–65535
Interface Configuration, Tunnel Profile Configuration
Chapter 8: T Commands
1361