Update-Source - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

update-source

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
For OSPF:
[ no ] update-source loopback interfaceSpecifier
For PIM:
update-source interfaceType interfaceSpecifier
no update-source [ interfaceType interfaceSpecifier ]
For RIP:
[ no ] update-source interfaceType interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
Specifies the loopback interface whose local address is used as the source address for
the OSPF, PIM, or RIP connection to a remote neighbor. The no version deletes the source
address from the connection.
NOTE: For PIM, this command is typically used when you configure PIM
remote neighbors to run multicast services over BGP/MPLS VPNs. That
functionality is no longer supported.
interfaceSpecifier—Integer, in the range 1–4294967293, identifying the loopback
interface
interfaceType—Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Remote Neighbor Configuration
Chapter 9: U, V, W, and Y Commands
1395