Ubr - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

ubr

Syntax
Release Information
Description
Options
Mode
1382
ubr [ pcr ]
no ubr
Command introduced in JunosE Release 7.1.0.
ATM VC Class Configuration mode added in JunosE Release 7.3.0.
In ATM VC Configuration mode, configures the unspecified bit rate (UBR) service category
on an ATM PVC. Optionally, you can specify a peak cell rate (PCR). The ubr command
is valid only for data PVCs; you cannot use this command for control (ILMI or signaling)
PVCs. The no version restores the default service category, UBR without a PCR.
In ATM VC Class Configuration mode, configures the UBR service category as part of a
VC class definition that you assign to an ATM data PVC. The no version restores the
default service category, UBR without a PCR, in the VC class.
pcr—Peak cell rate, in Kbps, in the range 0–149760 (for OC3 ATM modules) or
0–599040 (for OC12 ATM modules)
ATM VC Configuration, ATM VC Class Configuration
Copyright © 2010, Juniper Networks, Inc.