Vc-Class Atm - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

vc-class atm

Syntax
Release Information
Description
Options
Mode
1404
[ no ] vc-class atm vcClassName
Command introduced in JunosE Release 7.3.0.
Creates and names a VC class for an ATM data PVC. This command accesses ATM VC
Class Configuration mode, from which you can configure a set of attributes for an ATM
data PVC. The VC class can include attributes for the service category, encapsulation
method, F5 OAM options, and Inverse ARP. You then apply the attributes as a group by
assigning the VC class to an individual PVC, to all PVCs created on a specified ATM major
interface, to all PVCs created on a specified ATM 1483 subinterface, or to a base profile
from which bulk-configured VC ranges are dynamically created. The no version removes
the named VC class from the router.
You cannot remove a VC class that is currently assigned to at least one ATM PVC,
ATM 1483 subinterface, or ATM major interface without first issuing the no class-vc
command or the no show ip dhcp-local binding command to remove the VC class
association with the PVC, interface, or subinterface.
NOTE: For information about the total number of ATM VC classes supported
on the router, see JunosE Release Notes, Appendix A, System Maximums.
vcClassName—Name of the VC class; a string of up to 32 alphanumeric characters
Global Configuration
Copyright © 2010, Juniper Networks, Inc.