Tunnel Peer-Identity - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

tunnel peer-identity

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
tunnel peer-identity { address ipAddress | subnet ipAddress subnetMask |
range ipAddressLow ipAddressHigh }
no tunnel peer-identity
Command introduced before JunosE Release 7.1.0.
Specifies the peer identity of the IPSec tunnel. The no version removes the peer endpoint.
ipAddress—IP address of the peer identity
subnetMask—Mask applied to the subnet IP address of the peer identity
ipAddressLow—Lower bound of the range of IP addresses of the peer identity
ipAddressHigh—Upper bound of the range of IP addresses of the peer identity
Interface Configuration
Chapter 8: T Commands
1369