Table of Contents
Advertisement
tx-connect-speed-method
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
tx-connect-speed-method { static-layer2 | dynamic-layer2 | qos | actual }
no tx-connect-speed-method
Command introduced in JunosE Release 8.0.0.
Configures for an AAA domain map (when used from Domain Map Tunnel Configuration
mode) or for an AAA tunnel group (when used from Tunnel Group Tunnel Configuration
mode) the method used to calculate the transmit connect speed of the subscriber's
access interface for establishing a tunneled L2TP session. This speed is reported in L2TP
Transmit (TX) Speed AVP 24. The no version removes configuration of the transmit
connect speed calculation method from the AAA domain map or AAA tunnel group.
static-layer2—Calculates the transmit connect speed of the subscriber's access
interface based on statically configured settings for the underlying layer 2 interface
dynamic-layer2—Calculates the transmit connect speed of the subscriber's access
interface based on dynamically configured settings for the underlying layer 2 interface
qos—Calculates the transmit connect speed of the subscriber's access interface based
on settings determined by QoS
actual—Calculates the transmit connect speed of the subscriber's access interface as
the lesser of the dynamic-layer2 value or the qos value
Domain Map Tunnel Configuration, Tunnel Group Tunnel Configuration
Chapter 8: T Commands
1379
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 and is the answer not in the manual?
Questions and answers