Subaru IMPREZA GD 2007 Series Manual page 3568

asieps_tobira_IM_US.book 25 ページ ２０１２年１月１７日 火曜日 午後３時４８分
6. Airbag Connector
A: PROCEDURE
1. BUCKLE SWITCH & OCCUPANT
DETECTION CONTROL MODULE
1) How to disconnect
(1) Move the slide lock (A) in the direction of ar-
row.
(2) While holding the slide lock (A) in the moved
position, disconnect the connector.
CAUTION:
When pulling the slide lock or disconnecting
connector, be sure to hold the connector, not
the harness.
2) How to connect
Holding the connector (A), and push it in carefully
until a clicking sound is heard.
CAUTION:
Be sure to insert the connector in until it is
locked. Then pull it gently to make sure that it is
locked.
Airbag Connector
(A)
AB-00721
AB-00016
AB(diag)-25
AIRBAG SYSTEM (DIAGNOSTICS)
2. DRIVER'S AIRBAG MODULE AND
PRETENSIONER
1) How to disconnect
(1) Using a flat tip screwdriver, pry the push
lock upward to unlock.
(2) Pull the connector to disconnect from the
driver's airbag module assembly or the retractor
assembly.
2) How to connect
Connect the connector in the reverse order of dis-
connecting. At this time, be sure to insert the push
lock until a clicking sound is heard.
CAUTION:
• Be sure to insert the connector in until it is
locked. Then pull it gently to make sure that it is
locked.
• Be sure to push the push lock in securely.
NOTE:
The connector cannot be connected when the push
lock is in the lock position. Move the push lock to
the release position and connect the connector.
AB-00478
AB-00479
AB-00480