asieps_tobira_IM_US.book 28 ページ 2012年1月17日 火曜日 午後3時48分
AIRBAG SYSTEM (DIAGNOSTICS)
7. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
When malfunction of airbag system occurs, the
DTC stored in airbag control module will be read
out.
1) Prepare the Subaru Select Monitor kit. <Ref. to
AB(diag)-8, SPECIAL TOOL, PREPARATION TOOL,
General Description.>
2) Connect the diagnosis cable to the Subaru Se-
lect Monitor.
3) Connect the Subaru Select Monitor to the data
link connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver's
side).
(2) Connect the diagnosis cable to the data link
connector.
CAUTION:
Do not connect scan tools other than the Suba-
ru Select Monitor.
4) Turn the ignition switch to ON (engine OFF) and
run the Subaru Select Monitor.
(1) Power switch
5) On the «Main Menu» display screen, select {Each
System Check}.
6) On the «System Selection Menu» display screen,
select {Airbag System}.
7) Select [OK] after the {Airbag System} is displayed.
Subaru Select Monitor
8) On the «Airbag System» screen, select the
{DTC Display}.
NOTE:
• For details concerning the operation procedure,
refer to the "SUBARU SELECT MONITOR OPER-
ATION MANUAL".
• For details concerning DTCs, refer to List of Di-
agnostic Trouble Code (DTC). <Ref. to AB(diag)-
43, List of Diagnostic Trouble Code (DTC).>
EN-01163
(1)
ABS00114
AB(diag)-28