Subaru IMPREZA GD 2007 Series Manual page 3572

asieps_tobira_IM_US.book 29 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2. DISPLAY OF STATUS INFORMATION
Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch and
seat position sensor, or when the seat belt buckle switch and seat position sensor has been replaced.
1) On the «Main Menu» display screen, select {Each System Check}.
2) On the «System Selection Menu» display screen, select {Airbag System}.
3) On the «Airbag System» menu screen, select the {Status Data}.
The following table is for support data.
Item
Seat position sensor LH
Seat position sensor RH
Seat belt buckle switch LH
Seat belt buckle switch RH
Passenger's airbag firing status
*1: The seat position is forward.
*2: The seat position is rearward.
*3: Displayed when data other than before and behind the seat, such as the breakdown etc, is input.
*4: Displayed when it is initial.
*5: Seat position sensor not supported
*6: Seat belt fastened
*7: Seat belt not fastened
*8: Displayed when data other than belt fastened or not fastened, such as breakdowns is input.
*9: Seat belt buckle switch not supported
*10: Passenger's airbag operating state
*11: Passenger's airbag non-operating state
NOTE:
For details concerning the operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION
MANUAL".
3. CLEAR MEMORY MODE
Clear the DTC stored in the airbag control module after repairing the airbag system. (After the breakdown is
recovered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the
memory clear work is not performed.)
1) On the «Main Menu» display screen, select {Each System Check}.
2) On the «System Selection Menu» display screen, select {Airbag System}.
3) On the {Airbag System} display screen, select {Clear Memory}.
4) When the "Clear Memory?" is shown on the screen, select [OK].
5) When "Done" is displayed, turn off the Subaru Select Monitor.
NOTE:
For details concerning the operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION
MANUAL".
Subaru Select Monitor
*1 *2
Front position /Rear position /Other
*5
––
*6 *7 *8
Belted /Unbelted /Other /Initial Setting
*6 *7 *8
Belted /Unbelted /Other /Initial Setting
*10 *11 *4
ON /OFF /Initial Setting
AB(diag)-29
AIRBAG SYSTEM (DIAGNOSTICS)
Display
*3 *3 *5
/Initial Setting /––
*4 *9
/––
*4 *9
/––