Show Vrrp Ipv6 - Dell Z9500 Command Reference Manual

Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2.(1.0)
8.3.19.0
8.3.10.0
8.4.1.0
8.3.2.0
Usage If no options are specified, debug is active on all interfaces and all VRRP groups.
Information

show vrrp ipv6

View the IPv6 VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns
No Active VRRP group.
Syntax
show vrrp ipv6 [vrid] [interface] [brief] [vrf vrf-name]
Parameters
vrid
interface
brief
vrf vrf-name
Command
•
Modes
1902
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on E-Series ExaScale, C-Series, and S-Series.
Support was added for IPv6 VRRP groups in non-default
VRF instances.
Introduced on the E-Series TeraScale.
(OPTIONAL) Enter the virtual router identifier for the VRRP
group to view only that group. The range is from 1 to 255.
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
(OPTIONAL) Enter the keyword brief to view a table of
information on the VRRP groups.
Enter the keyword vrf followed by the name of the VRF to
view IPv6 VRRP groups corresponding to that VRF.
EXEC
Virtual Router Redundancy Protocol (VRRP)