LLDP-MED extend TLV
lldp admin-status
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode receives LLDPDUs only.
tx: Specifies the Tx mode. A port in this mode sends LLDPDUs only.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Description
Use the lldp admin-status command to specify the LLDP operating mode for a port or all the ports in a
port group.
Use the undo lldp admin-status command to restore the default LLDP operating mode.
The default LLDP operating mode is TxRx.
Examples
# Configure the LLDP operating mode as Rx for GigabitEthernet 2/0/3.
<Sysname> system-view
[Sysname] interface gigabitethernet2/0/3
[Sysname-GigabitEthernet2/0/3] lldp admin-status rx
lldp check-change-interval
Syntax
lldp check-change-interval value
Field
1-16
Description
MED related LLDP TLVs, including:
Capabilities TLV
Network Policy TLV
Location Identification TLV
Extended Power-via-MDI TLV
Inventory TLV, which can be hardware
revision TLV, firmware revision TLV, software
revision
TLV,
serial
manufacturer name TLV, model name TLV,
and asset id TLV.
number
TLV,