Qinq Ethernet-Type Service-Tag; Qos Apply Policy - 3Com S7906E Command Reference Manual

qinq ethernet-type service-tag

Syntax
qinq ethernet-type service-tag hex-value
undo qinq ethernet-type service-tag
View
Ethernet port view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
hex-value: Hexadecimal protocol type ID, in the range of 0x0001 to 0xFFFF except the protocol type
values listed in Table
Description
Use the qinq ethernet-type service-tag command to configure the TPID value of the service provider
network VLAN tags.
Use the undo qinq ethernet-type service-tag command to restore the default.
By default, the TPID value of the service provider network VLAN tags is 0x8100.
Examples
# Set the TPID value of the service provider network VLAN tags to 0x9100 for GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet2/0/1
[Sysname-GigabitEthernet2/0/1] qinq ethernet-type service-tag 9100

qos apply policy

Syntax
qos apply policy policy-name inbound
undo qos apply policy inbound
View
Ethernet port view, port group view
Default Level
2: System level
Parameters
inbound: Applies the specified policy to the traffic received on the current port(s).
policy-name: Policy name, a string of 1 to 31 characters.
Description
Use the qos apply policy command to apply a policy on a port or a port group.
1-1.
1-5