Gvrp Registration - 3Com S7906E Command Reference Manual

undo gvrp
View
System view, Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
None
Description
Use the gvrp command to enable GVRP globally (in system view), on a port (in Ethernet or Layer-2
aggregate interface view), or on all ports in a port group (in port group view).
Use the undo gvrp command to disable GVRP globally, on a port, or on all ports in a port group
depending on the view the command is executed.
By default, GVRP is disabled.
Note that:
To enable GVRP on a port, you need to enable it globally first.
The port where you enable/disable GVRP must be a trunk port.
GVRP is mutually exclusive with service loopback.
In an MSTP network, GVRP can run on only the CIST. In addition, blocked ports on the CIST
cannot receive/send GVRP packets.
Enabling GVRP on a Layer-2 aggregate interface enables both the aggregate interface and all
selected member ports in the corresponding link aggregation group to participate in dynamic VLAN
registration and deregistration. In addition, the GVRP configuration made on a link aggregation
member port can take effect only after the port is removed from the group. For more information
about link aggregation, refer to Link Aggregation Configuration in the Access Volume.
Related commands: display gvrp status.
Examples
# Enable GVRP globally.
<Sysname> system-view
[Sysname] gvrp
GVRP is enabled globally.

gvrp registration

Syntax
gvrp registration { fixed | forbidden | normal }
undo gvrp registration
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
1-9