Lldp Compliance Cdp; Lldp Enable - 3Com S7906E Command Reference Manual

To have your device work with Cisco IP phones, you must enable CDP-compatible LLDP globally and
then configure CDP-compatible LLDP to work in TxRx mode on the specified port(s).
Examples
# Configure CDP-compatible LLDP to operate in TxRx mode on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] lldp compliance admin-status cdp txrx

lldp compliance cdp

Syntax
lldp compliance cdp
undo lldp compliance cdp
View
System view
Default Level
2: System level
Parameters
None
Description
Use the lldp compliance cdp command to enable global CDP compatibility.
Use the undo lldp compliance cdp command to restore the default.
By default, global CDP compatibility is disabled.
Note that, as the maximum TTL allowed by CDP is 255 seconds, your TTL configuration, that is, the
product of the TTL multiplier and the LLDPDU transmit interval, must be no more than 255 seconds for
CDP-compatible LLDP to work properly with Cisco IP phones.
Related commands: lldp hold-multiplier, lldp timer tx-interval.
Examples
# Enable LLDP to be compatible with CDP globally.
<Sysname> system-view
[Sysname] lldp compliance cdp

lldp enable

Syntax
lldp enable
undo lldp enable
View
System view, Ethernet interface view, port group view
1-18