Port - 3Com S7906E Command Reference Manual

Table 1-3 display port command output description
Field
Interface
PVID
VLAN passing
Tagged
Untagged

port

Syntax
port interface-list
undo port interface-list
View
VLAN view
Default Level
2: System level
Parameters
interface interface-list: Specifies an Ethernet port list or Layer-2 aggregate interface list, in the format of
interface-list = { interface-type interface-number [ to interface-type interface-number ] }&<1-10>, where
&<1-10> indicates that you can specify up to 10 ports or port ranges.
Description
Use the port command to assign the specified access port(s) to the current VLAN.
Use the undo port command to remove the specified access port(s) from the current VLAN.
By default, all ports are in VLAN 1.
Note that:
This command is only applicable on access ports.
All ports are access ports by default. However, you can manually configure the port type. For more
information, refer to port link-type.
If you use this command to assign a Layer-2 aggregate interface to a VLAN, this command assigns
the Layer-2 aggregate interface but not its member ports to the current VLAN. For detailed
information about Layer-2 aggregate interfaces, refer to Link Aggregation Configuration in the
Access Volume.
Related commands: display vlan.
Examples
# Assign GigabitEthernet 2/0/1 through GigabitEthernet 2/0/3 to VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
Port name
Default VLAN ID of the port
VLANs whose packets are allowed to pass through the port.
VLANs whose packets are required to pass through the port tagged.
VLANs whose packets are required to pass through the port untagged.
1-9
Description