Lldp Compliance Admin-Status Cdp - 3Com S7906E Command Reference Manual

undo lldp check-change-interval
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
value: LLDP polling interval to be set, in the range 1 to 30 (in seconds).
Description
Use the lldp check-change-interval command to enable LLDP polling and set the polling interval.
Use the undo lldp check-change-interval command to restore the default.
By default, LLDP polling is disabled.
With LLDP polling enabled, LLDP detects for local configuration changes periodically. A local
configuration change triggers LLDPDU sending, through which neighboring devices can be informed of
the configuration change timely.
Examples
# Enable LLDP polling on GigabitEthernet2/0/3, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet2/0/3
[Sysname-GigabitEthernet2/0/3] lldp check-change-interval 30

lldp compliance admin-status cdp

Syntax
lldp compliance admin-status cdp { disable | txrx }
View
Ethernet interface view, port group view
Default Level
2: System level
Parameters
disable: Specifies the disable mode, where CDP-compatible LLDP neither receives nor transmits CDP
packets.
txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets.
Description
Use the lldp compliance admin-status cdp command to configure the operation mode of
CDP-compatible LLDP on a port or port group.
By default, CDP-compatible LLDP operates in disable mode.
1-17