3Com S7906E Command Reference Manual page 217

At present, the AppleTalk-based protocol template cannot be associated with a port on an S7900E
series Ethernet switch.
Related commands: display protocol-vlan interface.
Examples
# Associate the hybrid port GigabitEthernet 2/0/1 with protocol 0 in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-Vlan2] protocol-vlan ipv4
[Sysname-Vlan2] quit
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] port link-type hybrid
[Sysname-GigabitEthernet2/0/1] port hybrid vlan 2 untagged
Please wait... Done
[Sysname-GigabitEthernet2/0/1] port hybrid protocol-vlan vlan 2 0
# Associate the hybrid Layer-2 aggregate interface Bridge-aggregation 1 with protocol 0 in VLAN 2,
assuming that Bridge-aggregation 1 does not have member ports.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-Vlan2] protocol-vlan ipv4
[Sysname-Vlan2] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done
[Sysname-Bridge-Aggregation1] port hybrid protocol-vlan vlan 2 0
# Associate the hybrid Layer-2 aggregate interface Bridge-aggregation 1 with protocol 0 in VLAN 2.
Among the member ports of the aggregation group corresponding to Bridge-aggregation 1, Ethernet
6/0/2 is an access port and Ethernet 6/0/3 is a trunk port.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-Vlan2] protocol-vlan ipv4
[Sysname-Vlan2] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation2] port link-type access
Please wait... Done.
Configuring GigabitEthernet2/0/1... Done.
Configuring GigabitEthernet2/0/1............................... Done.
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done.
Configuring GigabitEthernet2/0/1... Done.
1-25