Port Hybrid Pvid Vlan - 3Com S7906E Command Reference Manual

# Assign Layer-2 aggregate interface Bridge-aggregation 1 and its member ports to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port access vlan 3

port hybrid pvid vlan

Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
View
Ethernet interface view, port group view, Layer-2 aggregate interface view
Default Level
2: System level
Parameters
vlan-id: VLAN ID, in the range of 1 to 4094.
Description
Use the port hybrid pvid vlan command to configure the default VLAN ID of the hybrid port.
Use the undo port hybrid pvid command to restore the default.
By default, the default VLAN of a hybrid port is VLAN 1.
You can use a nonexistent VLAN as the default VLAN for a hybrid port. Removing the default VLAN of a
hybrid port with the undo vlan command does not affect the setting of the default VLAN on the port.
In Ethernet interface view, this command only applies to the current port.
In port group view, this command applies to all ports in the port group. For information about port
groups, refer to Ethernet Interface Configuration in the Access Volume.
In Layer-2 aggregate interface view, this command applies to the Layer-2 aggregate interface and
all its member ports. After you perform the configuration, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member ports.
If it fails to do that on an aggregation member port, it simply skips the port and moves to the next
port. For information about Layer-2 aggregate interfaces, refer to Link Aggregation Configuration in
the Access Volume.
The local and remote hybrid ports must use the same default VLAN ID for the traffic of the default
VLAN to be transmitted properly.
After configuring the default VLAN for a hybrid port, you must use the port trunk permit vlan
command to configure the hybrid port to allow packets from the default VLAN to pass through, so
that the port can forward packets from the default VLAN.
Related commands: port link-type, port hybrid vlan.
1-11