Lldp Encapsulation Snap - 3Com S7906E Command Reference Manual

Default level
2: System level
Parameters
None
Description
Use the lldp enable command to enable LLDP.
Use the undo lldp enable command to disable LLDP.
By default, LLDP is enabled at both the global and port levels.
Note that LLDP takes effect on a port only when it is enabled both globally and on the port.
Examples
# Disable LLDP on GigabitEthernet 2/0/3.
<Sysname> system-view
[Sysname] interface gigabitethernet2/0/3
[Sysname-GigabitEthernet2/0/3] undo lldp enable

lldp encapsulation snap

Syntax
lldp encapsulation snap
undo lldp encapsulation [ snap ]
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Description
Use the lldp encapsulation snap command to configure the encapsulation format for LLDPDUs as
SNAP on a port or a group of ports.
Use the undo lldp encapsulation command to restore the default encapsulation format for LLDPDUs.
By default, Ethernet II encapsulation applies.
The command does not apply to LLDP-CDP packets, which use only SNAP encapsulation.
1-19