Portal Server Method - 3Com S7906E Command Reference Manual

Using the undo portal server server-name command, you remove the specified portal server if
the specified portal server exists and there is no user on the interfaces referencing the portal
server.
The configured portal server and its parameters can be removed or modified only when the portal
server is not referenced by an interface.
To remove or modify the settings of a portal server that has been referenced by an interface, you
must remove the portal configuration on the interface using the undo portal command.
Related commands: display portal server.
Examples
# Configure portal server pts, setting the IP address to 192.168.0.111, the key to portal, and the
redirection URL to http://192.168.0.111/portal.
<Sysname> system-view
[Sysname] portal server pts ip 192.168.0.111 key portal url http://192.168.0.111/portal

portal server method

Syntax
portal server server-name method { direct | layer3 | redhcp }
undo portal
View
Interface view
Default Level
2: System level
Parameters
server-name: Name of the portal server, a case-sensitive string of 1 to 32 characters.
method: Specifies the authentication mode to be used.
direct: Direct authentication.
layer3: Layer 3 authentication.
redhcp: Re-DHCP authentication.
Description
Use the portal server command to enable portal authentication on an interface, and specify the portal
server to be referenced and the authentication mode.
Use the undo portal command to disable portal authentication on an interface.
By default, portal authentication is disabled on an interface.
Note that: The portal server to be referenced must exist.
Related commands: display portal server.
Examples
# Enable portal authentication on interface VLAN-interface 100, setting the portal server to pts, and
the authentication mode to direct.
1-17