Suzuki Baleno Manual page 752

7B1-68 AUTOMATIC TRANSMISSION
1. Dipstick
2. A/T fluid filler tube
3. "FULL HOT" mark
1. Radiator
2. Inlet hose (Outlet from oil cooler)
3. Outlet hose (Inlet to oil cooler)
CHANGING FLUID
1) Lift up vehicle.
2) With engine is cool, remove drain plug from oil pan and drain
3) Install drain plug.
1. Drain plug
2. Mounting member
4) Lower vehicle and fill proper amount of an equivalent of DEX-
5) Check fluid level referring to "FLUID LEVEL" in this section.
4. "LOW HOT" mark
5. Fluid level
OIL COOLER HOSES
The rubber hoses for the oil cooler should be replaced at specified
interval. When replacing them, be sure to note the following.
to replace clamps at the same time
to insert hose as far as its limit mark
to clamp clamps securely
A/T fluid.
Tightening Torque
(a): 40 N·m (4.0 kg-m, 29.0 lb-ft)
RON -III.
Fluid specification
An equivalent of DEXRON -III or DEXRON -IIE
When draining from g
drain plug hole
When overhauling When overhauling
Fluid capacity
2.4 liters
G16
(5.07/4.22 US/Imp.pt.)
2.6 liters
J18
(5.49/4.58 US/Imp.pt.)
5.65 liters
G16
(11.94/9.94 US/Imp.pt.)
5.85 liters
J18
(12.36/10.30 US/Imp.pt.)