Lamp Comes “On” Steady - Suzuki Baleno Manual

TABLE – B ABS WARNING LAMP CIRCUIT CHECK – LAMP COMES "ON"
STEADY
Refer to TABLE – A for System Circuit Diagram and Circuit Description.
INSPECTION
STEP
1 Perform diagnostic trouble code check. Is there any
DTC (including code No.12, NO CODES on SUZUKI
scan tool) exists?
2 Is malfunction DTC (other than code No.12) exists at
step 1?
3 1) Disconnect ABS hydraulic unit / control module
connector (1). (See Fig. 1)
2) Check for proper connection to ABS hydraulic
unit / control module connector at terminals
"E116-30", "E116-3" and "E116-1".
3) If OK, turn ignition switch ON and measure voltage
at terminal "E116-3" of connector.
Is it 10 – 14 V?
4 1) With ABS control module connector disconnected,
turn ignition switch ON and light ABS warning
lamp.
2) Connect terminal "E116-30" of disconnected con-
nector to ground using service wire.
Does "ABS warning lamp" turn off?
5 1) Measure resistance from connector terminal
"E116-1" to body ground.
Is continuity indicated?
Fig. 1
ACTION
ANTILOCK BRAKE SYSTEM (ABS) 5B-17
YES
Go to step 2.
Go to step 7 of ABS
diagnostic flow table in
this section.
Go to step 4.
Go to step 5.
Substitute a known-
good ABS hydraulic
unit/control module as-
sembly and recheck.
NO
Go to step 3.
Go to step 3.
"BLK/ WHT" circuit
open.
"BLK/ ORG" circuit or
"BLK/ WHT" circuit be-
tween ABS warning
lamp relay and dot clo-
sure open.
"RED/ BLU" circuit
shorted to ground.
If wire and connection
are OK, replace ABS
warning lamp relay.
"BLK" circuit open.