Sliding Roof - Suzuki Baleno Manual

SLIDING ROOF

1. Bolt (Torx T25)
REMOVAL
NOTE:
If slidIng roof is not positioned properly in relation with fully
closed position of drive gear, it will not operate properly even
though its functional parts are all In good condition. To ensure
proper positioning, when removing drive gear assembly, be
sure to close slIding roof completely before removal.
1) Remove sliding roof weatherstrip.
2) Remove roof lining. Refer to "ROOF LINING" in this section.
3) Remove sliding roof glass by removing bolts (torx).
CAUTION:
After removing sliding roof glass, do not turn ON slid-
ing roof switch so as not to drive sliding roof drive
gear assembly.
4) Disconnect drain hose.
BODY SERVICE 9-63
1. Sliding roof glass
2. Sliding roof weatherstrip
3. Sunshade trim
4. Sunshade trim stopper
5. Sliding roof drive cable
6. Sliding roof drive cable stopper
7. Sliding roof drive cable guide
8. Sliding roof drive gear assembly
9. Control relay
10. Sliding roof deflector
11. Sliding roof guide block
12. Sliding roof housing
13. Sliding roof rail
14. Roof drip rear channel