Suzuki Baleno Manual page 669

1. One-way clutch
2. Rear planetary gear assembly
CLOCKWISE . . . . . . . . . . . . . FREE
COUNTERCLOCKWISE . . . LOCKED
15) Check one-way clutch direction.
1. Rear planetary gear
2. One-way clutch
A: Free rotation
16) Install rear planetary thrust washers on rear planetary gear.
1. Thrust washer
17) Install rear planetary gear with teeth of 1st-reverse brake discs
18) Install one-way clutch race snap ring into groove of transmis-
19) Place one-way clutch on rear planetary gear and while turning
Provisionally assemble one-way clutch and rear planetary
gear, then turn them by hand.
They should rotate freely in arrow direction A but lock in the
other way.
Remove one-way clutch and keep its correct side in mind until
it is installed into transmission.
Apply grease to thrust washers and fit them before and behind
planetary gear, one each.
Make sure that different lug shapes match slots in planetary
gear.
"A": SUZUKI SUPER GREASE C, 99000-25030
aligned.
After installing rear planetary gear, check thrust washers and
races for proper installation by moving rear planetary gear up
and down lightly by hand. If gear assembly makes clear sound
like "Click" when moved up and down, washers and races are
installed in place. But if no sound or thick one is heard, it is pos-
sible that they are out of place
In such case, remove gear assembly and check.
sion case.
planetary gear clockwise by hand, insert one-way clutch to
correct position.
After installing one-way clutch to rear planetary gear, check to
confirm that planetary gear turns clockwise but locks in the
other way
NOTE:
Rotation check must be performed without fail.
AUTOMATIC TRANSMISSION (3 A/T) 7B-99