Suzuki Baleno Manual page 1034

9-34 BODY SERVICE
[A]
[B]
[A]: Hatch-back model
[B]: Wagon model
11) For hatch-back model:
Holding rubber sucker grips, press glass against door so that
clearances "f" and "g" become even.
For wagon model:
Press glass against body so that clip hole in body matches with
clip position on glass.
1. Rubber sucker grip
12) Check for water leakage by running water from hose over win-
dow. If leakage is found, dry window and fill leaky point with
adhesive. If water still leaks even after that, remove glass and
start installation procedure all over again.
NOTE:
Do not use high pressure water.
Do not blow compressed air directly at adhesive ap-
plied part when drying.
Do not use an infrared lamp or the like for drying.
CAUTION:
Upon completion of installation, note the following.
Sudden closing of door before adhesive is com-
pletely set may cause glass to become loose or to
come off. Therefore, if door is opened or closed
before adhesive is completely set, make sure to
open all door glasses and use proper care.
If molding is not securely in place, hold it down
with a tape until adhesive is completely set.
Each adhesive has its own setting time. Be sure to
refer to maker's instruction, check setting time of
adhesive to be used and observe precautions to
be taken before adhesive is set.
Refrain from driving till adhesive is completely set
so as to ensure proper and sufficient adhesion.