Suzuki Baleno Manual page 885

1. Power wrench
2. Flange
1. Drive bevel pinion
2. Rear bearing
3. Bearing puller
1. Brass bar
1. Brass bar
10) Remove caulking of flange nut with special tool and power
wrench.
(C): 09930-40113
11) Remove flange and washer from drive bevel pinion, and then
drive out drive bevel pinion.
Special Tool
(D): 09913-85230
(E): 09913-65135
12) Remove rear bearing by using bearing puller and press.
13) Using a hammer and brass bar, drive out front bearing outer
race.
14) Drive out rear bearing outer race in the same way as in the
Step 13).
REAR DIFFERENTIAL 7F-7