Suzuki Baleno Manual page 515

1. Differential assembly
2. Transmission right case
3. Speedometer driven gear
1. Reverse gear shaft
2. Right case
1. REV gear
2. REV gear shift
lever
3. Washer
4) Insert speedometer driven gear case assembly applied with oil
to its O-ring and gear, then tighten it with bolt.
Tightening Torque
(a): 5.5 N·m (0.55 kg-m, 4.0 Ib-ft)
LEFT CASE
1) For installation procedure, refer to Steps 3) and 4) of Differential
to Left Case of Assembly Unit in SECTION 7A.
2) Make reverse idler gear with reverse gear shift lever, insert re-
verse gear shaft into case through idler gear and then align A
in shaft with B in case.
NOTE:
3. Reverse idle gear
D Make sure that washer has been installed in shaft at
A: Align with B
D Check to confirm that reverse gear shift lever end has
3) For installation procedure, refer to Steps 6) to 8) of Differential
to Left Case of Assembly Unit in SECTION 7A.
4) Install another case bolts from clutch housing side and tighten
them to specification.
MANUAL TRANSMISSION (J18 ENGINE MODEL) 7A1-17
CAUTION:
D While inserting case assembly into transmission,
turn final gear by hand slightly so that gear can
mesh easily.
D Never push or hit slit portion of case when inserting
it. Such attempt may cause case to break.
above the gear.
clearance 1 mm (0.04 in.) to idler gear groove.