Suzuki Baleno Manual page 661

ASSEMBLING UNIT
CAUTION:
D Automatic transmission consists of highly precise parts. As even a flaw in a small part may cause
oil leakage or decrease in function, check each part carefully before installation.
D Clean all parts with compressed air. Never use wiping cloths or rags.
D Before assembling new clutch discs and brake band, soak them in automatic transmission fluid
for at least 2 hours.
D Be sure to use new gaskets and O rings.
D Lubricate O rings with automatic transmission fluid.
D Apply automatic transmission fluid on sliding or rotating surfaces of the parts before assembly.
D Use yellow petrolatum grease or Suzuki super grease C to retain parts in place.
D Be sure to install thrust bearings and races in correct direction and position as shown in figure
below.
D Make sure that snap ring ends are not aligned with one of cutouts and are installed in groove cor-
rectly.
D Do not use adhesive cements on gaskets and similar parts.
D Be sure to torque each bolt and nut to specification.
1. Rear ring gear races and bearing
2. Front planetary gear race and bearing
3. Ring gear races and bearing
4. Ring gear races and bearing
5. Input shaft bearing and races
6. Bearing
7. Race
8. Output shaft
9. Ring gear flange
10. 1st-reverse brake
11. Rear planetary gear
12. One-way clutch
13. Sun gear
14. Front planetary gear
AUTOMATIC TRANSMISSION (3 A/T) 7B-91
15. Ring gear flange
16. Forward clutch
17. Input shaft
18. Direct clutch
19. Oil pump