Suzuki Baleno Manual page 756

7B1-72 AUTOMATIC TRANSMISSION
1. Input shaft speed sensor
1. Input shaft speed sensor
1. Input shaft speed sensor
INPUT SHAFT SPEED SENSOR
(FORWARD CLUTCH CYLINDER
REVOLUTION SENSOR)
INSPECTION
1) Disconnect negative cable at battery.
2) Disconnect input shaft speed sensor coupler.
3) Check resistance between input shaft speed sensor terminals.
Input shaft speed
sensor standard resistance: 387 – 473 W at 20 C (68 F)
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect input shaft speed sensor coupler.
3) Remove input shaft speed sensor by removing its bolt.
INSTALLATION
1) Apply A/T fluid to input shaft speed sensor O-ring.
2) Install input shaft speed sensor to A/T case and tighten bolt to
specified torque.
Tightening Torque
(a): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
3) Connect input shaft speed sensor coupler to input shaft speed
sensor.
4) Connect negative cable to battery.
VEHICLE SPEED SENSOR
(VSS, SPEEDOMETER DRIVEN GEAR)
Refer to Section 7A for removal, installation and inspection.
THROTTLE POSITION SENSOR
INSPECTION
Check throttle position sensor referring to Section 6E1, 6E2, 6E3
or 6E4.
ENGINE COOLANT TEMPERATURE SENSOR
INSPECTION
Check engine coolant temperature sensor referring to Section
6E1, 6E2, 6E3 or 6E4.