Suzuki Baleno Manual page 1029

11) Peel paper from moldings.
12) Holding rubber sucker grips, place glass onto body by aligning
1. Rubber sucker grip
13) Remove matchmarks.
14) Install new back window lower moldings.
15) Check for water leakage by pouring water over window
mating matchmarks in Step 4) and press it.
through a hose. If leakage is found, dry window and fill leaky
point with adhesive. If water still leaks even after that, remove
glass and start installation procedure all over again.
NOTE:
Do not use high pressure water.
Do not blow compressed air directly at adhesive ap-
plied part when drying.
Do not use an infrared lamp or the like for drying.
CAUTION:
Upon completion of installation, note the following.
Sudden closing of door before adhesive is com-
pletely set may cause glass to become loose or to
come off. Therefore, if door is opened or closed
before adhesive is completely set, make sure to
open all door glasses and use proper care.
If molding is not securely in place, hold it down
with a tape until adhesive is completely set.
Each adhesive has its own setting time. Be sure to
refer to maker's instruction, check setting time of
adhesive to be used and observe precautions to
be taken before adhesive is set.
Refrain from driving till adhesive is completely set
so as to ensure proper and sufficient adhesion.
BODY SERVICE 9-29